look at the old pads to see if one was more worn or unevenly worn
raise both front wheels and see how they spin . then pump up pedal hard and check pads are freeing , ie spin again
need to find out, is it the hydrollicks or physical
are both sides getting hot.
did you bleed in correct pattern, have you regreased the slide pins
I doubt its the mc
file the pad pins down, file out the carrier slides grind of the pads at the top to large chamfer. bleed again with fresh fluid , best down with a good flow and oscillating. maybe to put a block of wood under pedal to prevent mc seal flip.
hope you changed both hoses.
ive just been through all this my self with rear i10 disc brakes
|